Remote Control Usage - Dimplex SF55992-AU Parts And Service Manual

The fireplace is supplied with a radio frequency remote control. This remote control has
a range of approximately 50 feet. (15.25m), it does not have to be pointed at the
fireplace and can pass through most obstacles (including walls).
FIGURE 1
Level 1 Indicator Level 3 Indicator
Level 2 Indicator

REMOTE CONTROL USAGE

Remote Control Initialization
This procedure is required every time there is a loss of
power to the remote control in the fireplace. (i.e. power
failure, breaker tripped, main power switch is turned off)
Remote Control Usage
The remote control operates the fireplace levels
sequentially. The level is increased every time the ON
button on the transmitter is pressed. The fireplace can
be turned off at any point by pressing the OFF button
on the remote control transmitter.
MANUAL SELECTION SWITCH
Operates fireplace in the same matter as the remote
control transmitter. Pressing the right side of this switch
has the same effect as the
remote control and the right side has the same effect as
the
the left activates Level 1, twice activates Level 2, three
times activates Level 3. Pressing to the left side turns
the fireplace off.
1. Ensure that power is supplied through main
service panel.
2. Locate manual controls (refer to OPERATION
section).
3. Activate main power switch, red indicator lights will
flash momentarily.
4. Press ON button located on the remote control
transmitter (FIGURE 1). This will synchronize the
remote control transmitter and receiver.
Level 1: The flame effect is turned on and the first red
indicator light flashes momentarily.
Level 2: The flame effect remains on, the heater is
activated to the low heat setting, and the first and
second red indicator lights flash momentarily.
Level 3: The flame effect remains on, the heater is set
to the high heat setting, and all three red indicators
flash momentarily.
button of the remote control. Pressing once to
button on the
2