To Replace Heater Assembly - Dimplex SF55992-AU Parts And Service Manual

26” fireplace
Table of Contents

Advertisement

If the fireplace was operating prior to servicing allow at least 10 minutes for light bulbs
and heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.

TO REPLACE HEATER ASSEMBLY

1. Remove the firebox trim by placing your hand on the grill section, grasping the
trim and pulling outwards releasing the retainer clips.
2. Remove the firebox from the mantel.
3. Lower the grill covering the controls.
4. Remove the retaining screws on the top cover and remove the top, placing it
upside down on the top of the unit being careful not to damage any of the wiring.
5. Locate the heater assembly mounted on the top panel and disconnect the wiring
clips and connections noting their original locations.
NOTE: A small slot screwdriver is required to remove some of the heater
connections.
6. Turn the top over, remove the heater mounting screws and remove the heater
assembly by sliding it back to release mounting tabs.
7. Properly orientate the new heater assembly and connect all of the wiring
connections.
8. Reassemble in the reverse order as above.
15

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents