To Replace Lower Light Bulbs - Dimplex SF55992-AU Parts And Service Manual

If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
Light bulbs need to be replaced when you notice a dark section of the flame or when the
clarity and detail of the log exterior disappears. There are two bulbs at the top of the
opening that illuminates the log set exterior and four bulbs under the log set which
generate the flames and embers.
It is a good idea to replace all of the light bulbs at one time if they are close to the end of
their rated life. Group replacement will reduce the number of times you need to open
the unit to replace the light bulbs.

TO REPLACE LOWER LIGHT BULBS

1. Remove the firebox trim by placing your hand on the grill section, grasping the
trim and pulling outwards releasing the retainer clips.
2. Remove the mounting screw in the center of the glass and remove the retainer
bracket.
3. Remove the glass by lifting up from the bottom.
CAUTION
Even though the glass is safety glass it may break if bumped, struck of dropped.
Care must be taken when handling the glass.
4. Only handle the log set by the ember bed and not by the logs. To remove the log
set lift up the front edge of log set until it clears the front tabs. Pull out until the
rear tab clears the back ledge, and then lift out.
5. Replace bulb(s) that require replacement, holding onto the light socket when
while unscrewing.
6. Replace the log by pushing it down and in until it rests against the mirror.
7. Reassemble in the reverse order as above.
LOWER BULB-Quantity 4 chandelier or candelabra bulbs with an E-12 (small)
socket base, 60 watt rating.
CAUTION DO NOT EXCEED 60 WATTS PER BULB
8