Appendix E. General Attributes Required When Using A Tty Terminal - IBM RS/6000 44P 170 Installation Manual

Appendix E. General Attributes Required When Using a TTY
Terminal
The following general attributes are the default settings for the diagnostic programs. Be
sure your terminal is set to these attributes.
Note: These attributes should be set before the diagnostic programs are loaded.
General Setup
Attributes
Machine mode
Generated Code Set
Screen
Row and Column
Scroll
Auto LF
CRT saver
3151 3151
/11/31/41 /51/61 /3164
Settings Settings Settings
3151 3151 PC 3161 or
3164
ASCII
Normal Normal
24 x 80 24 x 80
Jump Jump Jump
Off Off Off
Off Off 10
3161 Description
The diagnostic programs are set
to emulate use of the 3161 ASCII
Display Terminal. If your terminal
can emulate a 5085, 3161 or
3164 terminal, use these attribute
settings. Otherwise, refer to your
operator's manual, compare the
attribute descriptions with those
of your terminal, and set your
attributes accordingly.
Uses the EIA-232 interface
protocol.
Uses the EIA-232 interface
protocol.
When the last character on the
bottom line is entered, the screen
moves down one line.
For the "On" setting, pressing the
Return key moves the cursor to
the first character position of the
next line. For the "Off" setting,
pressing the Return key moves
the cursor to the first character
position of the current line. The
CR and LF characters are
generated by the New line
setting.
The "10" setting causes the
display screen to go blank if there
is no activity for 10 minutes.
When the system unit sends data
or a key is pressed, the screen
contents display again.
65