IBM RS/6000 44P 170 Installation Manual page 45

Before performing these procedures, read "Safety Notices" on page vii. Use the
following steps when removing or installing memory modules.
1. With one hand, touch any metal surface of the chassis to minimize static electrical
charges, and then pick up the memory module.
2. Locate the memory module connector on the system board.
3. Ensure that the locking tabs are open.
4. Insert the memory module firmly into the connector. The locking tabs located on
each end of the memory module connector move back into the locked position.
5. Ensure that the locking tabs are in the secure position. (Tabs are in the secure
position when they are parallel to the side of the connector.)
6. If you have additional options to install, refer to "Option List" on page 30 for the
appropriate page number, and skip to that section. Otherwise, continue with these
steps.
7. Replace the cover support bridge as described in "Replacing the Cover Support
Bridge" on page 26.
8. Replace the system unit left cover as described in "Replacing the Left Side Cover"
on page 25.
9. Reconnect all cables.
10. Turn on the power.
Chapter 3. Installing Options for the RS/6000 44P Series Model 170
33