Battery; Removing The Battery - IBM RS/6000 44P 170 Installation Manual

Battery

Use the following steps to remove or replace the battery.
CAUTION:
A lithium battery can cause fire, explosion, or a severe burn. Do not recharge,
disassemble, heat above 100°C (212°F), solder directly to the cell, incinerate, or
expose cell contents to water. Keep away from children. Replace only with the
part number specified for your system. Use of another battery may present a risk
of fire or explosion.
The battery connector is polarized; do not attempt to reverse polarity.
Dispose of the battery according to local regulations.

Removing the Battery

1. Shut down the system unit as described in "Stopping the System Unit" on page 22.
2. Unplug the power cable.
3. Remove the left side cover as described in "Removing the Left Side Cover" on
page 23.
Note: To prevent damage to your machine, you can lay it on its side. Do not knock
4. Remove the cover support bridge as described in "Cover Support Bridge" on
page 26.
5. Locate the battery on the system board.
the machince over.
Chapter 3. Installing Options for the RS/6000 44P Series Model 170
27