Media Drives; Removing Cd-Rom Drives And Tape Drives; Installing Media Drives - IBM RS/6000 44P 170 Installation Manual

Media Drives

Use the following steps when removing or replacing a media device.
Attention:

Removing CD-ROM Drives and Tape Drives

Note: The front cover does not need to be removed to service media devices.
Air Duct Air Duct

Installing Media Drives

1. The CD-ROM drives and Tape drives are designed to have the cables connected
and disconnected from the front of the system.
v Set the SCSI address jumpers at the rear of the drive to the correct address
Do not open the drive; no user adjustments or serviceable parts are inside.
1. Shut down the system as described in "Stopping the System Unit" on
page 22.
2. Unplug the power cable.
3. Remove the left side cover as described in "Removing the Left Side Cover"
on page 23.
4. Remove the air duct located between the power supply and media bay.
5. Remove the screws that secure the media drive to the system unit.
6. Slide the drive forward and out the front of the system.
7. Disconnect the power and data cables from the drive you are removing.
8. If you are removing the upper CD-ROM drive, disconnect the audio cable
from the rear of the CD-ROM drive.
before installation. Refer to the documentation provided with your device for
details on setting the SCSI address. Refer to "SCSI IDs and Bay Component
Locations" in the RS/6000 44P Series Model 170 Service Guide , order number
SA38-0560 for more information on SCSI addresses in your system unit.
Chapter 3. Installing Options for the RS/6000 44P Series Model 170
CD-ROM Drive CD-ROM Drive
45