Table of Contents
Advertisement
Media Drives (Diskette, CD-ROM, DVD-ROM, Tape, or Disk Drive)
Attention:
Neither the Linux nor the AIX operating system support hot-plugging any hot-pluggable PCI
adapters. All systems must be shut down and powered off before installing any PCI adapter. Use the
non-hot-pluggable adapter procedures when replacing a PCI adapter with the Linux operating system
installed.
Notes:
1. The two Slimline media bays can be used to house a CD-ROM, DVD-ROM, or diskette drive. For the
location of the two media bays, see the illustration on "Slimline Media". However, if your system has a
CD-ROM drive, place it in media bay 1.
2. Hot-swap devices are not supported in the optional media device bay.
Before performing this procedure, read the following:
v "Safety Notices" on page vii
v "Laser Safety Information" on page ix
Slimline Media
A Slimline diskette drive must be placed in the right drive slot, media bay 1, on the Model 275. Having two
diskette drives installed results in an error.
Note: Slimline media devices are not hot-swappable.
Slimline Media Drive Removal
To remove a Slimline media drive, do the following:
1. Push the blue plastic retaining tab away from the drive.
2. While holding the blue plastic retaining tab, grasp the drive and pull it out of the system.
Slimline Media Drive Replacement
To replace a Slimline media drive, do the following:
1. Push the blue plastic retaining tab away from the device slot.
2. While holding the blue plastic retaining tab, grasp the drive and push it into the system.
42
IntelliStation POWER 9114 Model 275 Installation Guide
Advertisement
Table of Contents
