Installing The Cs 120P In A Hard Ceiling; Painting The Baffle And Grille - Extron electronics CS 3T User Manual

Speedmount ceiling speaker system
Hide thumbs Also See for CS 3T:
Table of Contents

Advertisement

Installing the CS 120P in a Hard Ceiling

If you are installing the CS 123T in a hard ceiling (having no ceiling tiles), with the ceiling
structure in place, install the CS 120P:
NOTE: Installation in this type of ceiling must be done while access to the ceiling is

Painting the Baffle and Grille

NOTE: The cutout template that was used in
Painting the Baffle
1.
2.
3.
4.
5.
6.
It is the responsibility of the installer to identify a suitable mounting location and provide
the mounting hardware.
The CS 120P must be mounted as close as possible to the upper surface of the ceiling
material.
The lip of the CS 120P should protrude into the hole cut for the speaker.
Do not leave a gap between the CS 120P and the ceiling material.
still possible.
as a paint shield when painting the outer circumference of the baffle.
Remove the grille using the provided grille hooks and set the grille aside.
Place the cutout template over the center of the speaker so that inner portions of the
speaker (including the driver) are protected from the paint.
Tape over the center hole of the template to prevent any paint from entering the hole.
Tape over any exposed portion of the baffle that is normally covered by the grille. This
includes the perimeter outside of the template where the grille magnets are located.
ATTENTION:
Do not allow paint to touch the magnets, otherwise the grille installation will
not be as secure. Do not allow paint to enter the baffle groove where the grille
will reside, otherwise the grille may not contact the magnets properly for a
secure fit.
Ne laissez pas la peinture se déposer sur les aimants, sinon l'installation
de la grille ne sera pas aussi solide. Ne laissez pas la peinture rentrer dans
les rainures de la baffle, là où sera la grille : celle-ci pourrait ne plus être
correctement en contact avec les aimants et donc ne pas être maintenue.
Clean the outer perimeter of the baffle to be painted with a damp cloth.
Paint the outer baffle.
of the previous section will be used
step 2
CS 3T and CS 120P User Guide • Installation
30

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cs 123tCs 120p

Table of Contents