Table of Contents
Advertisement
13.
Installing the CS 3T in a Suspended Ceiling — Division of Labor
In a division of labor installation, an AV system contractor installs the CS 3T (final installation
phase). Use the following procedure:
NOTE: Observe all applicable building codes and local ordinances when installing the
1.
2.
3.
4.
NOTE: The zip tie located in the CS 120P must be attached to the driver assembly.
Replace the adjacent tile — Reinstall the adjacent tile if one was removed in
speaker.
Disconnect power
Power down all attached devices before proceeding.
—
(If the ceiling tile is already cut and in place, skip this step.)
Cut a hole for the CS 3T speaker — Use the provided cutout
template to outline the hole to be cut in the ceiling tile as described
below.
a.
Remove the ceiling tile.
b.
To find the center of the tile, use a tape measure to measure the
space between two opposite corners (diagonally), and mark the
half-way point.
c.
Position the center hole of the cutout template directly over the center of the tile
that you marked in step 2b.
d.
Using the provided cutout template, trace a circle on the ceiling tile as follows:
For installations in ceiling tiles that are NOT fiberglass: Trace a circle around
the cutout template.
NOTE: The fiberglass tile adapters are not needed and can be discarded.
For installations in 1-inch (2.54 cm) thick fiberglass ceiling tiles with the
CS 120P:
NOTE: A set of fiberglass tile adapters is provided with both the CS 3T and the
CS 120P. Only one set is needed to install the CS 26T with the CS 120P kit
in a 1-inch (2.54 cm) thick fiberglass tile. The adapter works
(2.54 cm) thick fiberglass tile.
i.
Place the fiberglass tile adapter around the outer diameter
of the template that was positioned in
ii.
Trace a circle around the outer diameter of the adapter.
e.
Cut out the circle traced in the ceiling tile.
f.
Replace the tile in the ceiling, ensuring that the hole in the tile
is aligned with the hole in the CS 120P.
Route the speaker wires — Route the speaker wires through the ceiling tile hole.
Remove the speaker grille — Carefully remove the grille from the front of the CS 26T.
NOTE: Grille hooks are provided for grille removal, if needed.
.
step 2c
CS 3T and CS 120P User Guide • Installation
.
step 5
with 1-inch
only
23
Advertisement
Table of Contents
