Table of Contents
Advertisement
2.4
FITTING THE BATTERIES TO THE RECEIVER UNIT
a)
4 off AA 1.5V batteries (found in the loose items pack) are to be fitted to
the battery holder located centrally on the fire, below the combustion
chamber as shown below in Fig. 7.
Fig. 7
b)
To remove the receiver unit, firstly loosen the retaining screw that holds
the unit in place.
c)
Slide off the cover from the reciever unit.
d)
Fit the 4 off AA batteries to the unit as shown in Fig. 8 and refit the
cover.
Fig. 8
e)
Re-fit the receiver unit into it's holder and tighten the retaining screw (do
not over-tighten as this may damage the unit). Take care not to trap or
damage any wires to the unit.
14
Receiver Unit
Receiver Unit
retaining screw
Hide quick links:
Advertisement
Table of Contents
