CipherLab 1564 User Manual page 83

Note: Read the "Set Connection" barcode first, and then the "MAC ID" barcode within 10
seconds.
Instead of producing the "MAC ID" barcode, you may have the scanner read the setup barcodes for
entering the MAC address.
Have the scanner read the "Abort" barcode to cancel the operation at any time while reading
setup barcodes for the MAC address. If the MAC address has not been completed yet, having
the scanner read the "Validate" barcode can cancel the operation as well.
Usage:
1. Read the barcode above.
2. Read the "Hexadecimal
3. Read the "Validate" barcode on the same page to complete this setting.
Exit SPP Master Mode
To stop such re-connection, have the scanner read "Reset Connection" or "Restore System
Defaults" barcode so that the current connection record (= MAC ID) will be cleared. Then, the
scanner will restart itself automatically. Go through the whole process in
to establish a new WPAN connection.
Users can also scan a single 2D barcode that combines the "Set Connection" and "MAC
ID" setup barcodes to connect with the target device. The example below is a 2D barcode
containing codes '#@CipherLab', '88686471166254' (Set Connection), '0x' (Prefix to the
target MAC ID), and '00D0176F0030' (MAC ID of the target device). Underlining the
digits is to make them more readable.
#@CipherLab886864711662540X00D0176F0030
2D One-Scan Setup Barcode for connecting with a target device
Command
#@CipherLab
88686471166254
Value" barcode on page 264 for the desired MAC address.
Purpose
Enter Setup
Set connection
Chapter 2 Selecting Output Interface
Enter MAC ID in
Hexadecimal...
Reset Connection
Update
3.2.3 Connect to Dongle
67