Yamaha Grizzly550 User Manual page 73

1. Throttle cable
2. Rear brake hose
3. Rear brake cable
4. Front brake hose
5. Negative battery lead
6. Final drive case breather hose
7. Starter motor lead
8. Throttle body breather hose
9. Intake air pressure sensor lead
10. TPS lead
11. Intake air temperature sensor lead
12. Fuel injector lead
13. Coolant temperature sensor lead
14. Wire harness
15. AC magneto lead
16. Rectifier/regulator lead
17. Fuel hose
18. Tail/brake light lead
19. Fuel pump lead
20. ISC unit lead
A. Route the throttle cable under the plastic cover.
B. Route the final drive case breather hose on top of
the leads.
C. Fasten the radiator fan motor breather hose and
throttle body breather hose with the holder.
D. Route the intake air pressure sensor lead to the
front of the throttle body breather hose and above
the ISC unit lead.
E. Fasten the ISC unit lead with the holder.
F. To engine
G. To air filter case
H. Route the fuel injector lead and coolant
temperature sensor lead to the outside of the
frame.
I. Pass the tail/brake light lead through the hole in
the rear fender.
J. Fasten the tail/brake light lead with the holder,
making sure that the coupler is positioned to the
rear of the holder.
K. Pass the throttle cable through the guide on the
plastic cover.
L. Insert the projection on the wire harness holder
into the hole in the plastic cover.
2-44
CABLE ROUTING
techsparkstudio.com