Hyundai DV2X708DU Instruction Manual page 74

2 AUDIO SETUP PAGE
There are two items in the submenu. They are ANALOG AUDIO SETUP, DIGITAL AUDIO
SETUP.
2.1 ANALOG AUDIO SETUP
2.1.1 DOWNMIX
LT/RT: When you play the 5.1-CH disc, the audio is mixed into left channel and right channel.
STEREO: When you play the 5.1-CH disc, the audio is mixed into stereo channel.
2.2. DIGITAL AUDIO SETUP
2.2.1 DIGITAL OUTPUT:
SPDIF OFF: There will be no digital audio signal output. (Coaxial off)
ALL: The digital audio signal output will be in RAW format.
PCM ONLY: The digital audio signal output will be in PCM format.
3 DOLBy DIGITAL SETUP
3.1 DOLBy DIGITAL SETUP
3.1.1 DUAL MONO
Stereo: Set audio output to the stereo output.
L-mono: Set audio output to the mono-left channel.
R-mono: Set audio output to the mono-right channel.
Mix-mono: Set audio output to the Mix mono channel.
3.1.2 DyNAMIC
When you watch films with large dynamic scope in low volume, for example at night, you can
adjust the dynamic value up to avoid losing sound details resulted from the low volume.
4 VIDEO SETUP PAGE
4.1 VIDEO OUTPUT:
OFF: Set video output to the composite.
YUV: Set video output in analog component video format when connecting to the Y/U/V termi-
nals.
P_YUV: Set video output as progressive YUV signals. Connection is the same as YUV.
RGB: Set video output in Red/Green/Blue format when connecting to the SCART terminal.
P_RGB: Set video output as progressive RGB signals. Connection is the same as RGB.
Note:: If the video setting differs from the physical video connection, the TV set may have no
picture.
You can also press [V-mode] on the remote controller to switch the video output mode.
4.2 ShARPNESS
There are three options (HIGH, MEDIUM and LOW) for you to choose in this item.
4.3 BRIGhTNESS and CONTRAST
Enter the two items respectively, then use direction key [Left]/[Right] to adjust the value, then
press [ENTER] to confirm it.
ENG - 4