Shut Down And Clean-Up; Storage - Kärcher HD 2.0/10 Ed Operator's Manual

STEP 1: Remove deter-
gent suction tube from
container and insert into
one gallon of fresh water.
Slide nozzle forward for
low pressure or use black
detergent nozzle. Pull
trigger on spray gun and
siphon fresh clean water
for one minute.
Pump Water
Inlet
STEP 5: Disconnect the
garden hose from the wa-
ter inlet on the machine.
Pump Storage
CAUTION: Always store your pres-
sure washer in a location where the
temperature will not fall below 32°F
(0°C). The pump in this machine is
susceptible to permanent damage if
CAUTION
frozen.
FREEzE DAMAGE IS NOT COvERED B Y WA R -
RANTY.
If you must store your pressure washer in a location
where the temperature is below 3°F, you can minimize
the chance of damage to your machine by draining your
machine as follows:
1. Stop the pressure washer and detach supply hose
and high pressure hose. Squeeze trigger of spray
gun to drain all water from the wand and hose.
. Restart pressure washer and let it run briefly (about
5 seconds) until water no longer discharges from
the high pressure outlet.
SHUTTINg DOWN AND CLEAN-UP
On/Off
Switch
STEP 2: Turn off machine
by turning switch to "OFF"
switch.
Pump Discharge Nipple
STEP 6: Disconnect the
high pressure hose from
pump discharge nipple.

STORAgE

#9.800-085.0 • Rev. 01/08
STEP 3: Turn off water
supply.
Safety
Latch
STEP 7: Engage the
spray gun safety lock.
STEP 4: Press trigger to
release water pressure.
9