Table of Contents
Advertisement
36
en | Programming
91-99 & 90 Registering wireless transmitters
Up to 10 wireless transmitters or detectors can be registered directly on
the keyboard with a code number contained in the transmitter itself. These
code numbers must be stored in the Carephone 62. To register a wireless
transmitter:
a.
Select programming step 91.
b.
The Carephone 62 announces: "Selection 91 is..."
c.
Press the button of the corresponding wireless transmitter.
d.
The Carephone 62 announces: "Selection 91 is..."
e.
Press C to confirm. The wireless transmitter is now stored.
Restoring the factory settings deletes all registered wireless transmitters.
Programming the next 10 wireless transmitters (11 to 20) can be done
only with the Configuration Manager or Alarm Management Systems.
6.2.5
Special key functions
Restore the programming steps to the factory settings
–
–
The unit is now ready for language selection.
CAUTION!
This function deletes all user settings and restores the factory
settings instead!
Reset the Carephone 62
–
The unit emits a beep and the unit reboots.
Easy wireless transmitter registering with top-cover installed
–
–
–
–
–
–
The code number of the wireless transmitter is registered in
Selection 91 (erasing the previous code number).
F.01U.141.162 | V6 | 2015.04
Press P and R together for at least two seconds.
The unit announces: "Setup reset".
Press R for at least one second.
Press buttons <Yellow> <Green> together for at least two
seconds.
The unit waits for a wireless signal.
Press the button of the wireless transmitter.
The unit acknowledges with a beep.
Press the button of the same transmitter to confirm.
The unit acknowledges with two beeps.
User Manual
Carephone 62
TeleAlarm
Advertisement
Table of Contents
