Table of Contents
Advertisement
28
en | Programming
41 to 44 IP Module programming steps
Refer to the user manual of the IP Module, these are optional steps.
45 Automatic test call hours
Program the interval between automatic test calls of the IP or GPRS
connection from the Carephone 62 to the monitoring centre in hours.
Select from 1 to 999 hours, 0 = off, factory setting = 10
47 SIM card PIN Code
Program the SIM PIN Code for the GSM Module. Max. length is 8 digits.
48 APN Code and Auto provider selection
Program the code for the Access Point Name (APN) between 0 and 99.
The default setting is 0. The APN codes can be found at Section A.7 APN
codes, page 68. Setting 99 is used to select a custom APN, available only in
extended programming. Access to these parameters is made with a
microSD memory card or by remote programming.
After programming the APN code, press C and access the substep auto
provider selection to select the automatic selection of the GPRS provider
(useful to avoid unwanted roaming costs, as in border areas).
Select 0 = roaming off, or 1 = on, factory setting = 0 (off).
If no APN is used, simply enter any value for the APN code to get access to
the auto provider selection.
49 Phone number of GSM Module (without country code)
Program the own phone number for the GSM Module to be established for
the Carephone 62. Maximum length is 22 digits. If the country codes of the
phone numbers of the Alarm receving center and the GSM module are the
same, then it does not need to be part of the phone number. If the country
code is different, then it must be part of the phone number. The phone
number can also be programmed with a keyboard shortcut: see
Section 6.2.5 Special key functions, page 36.
F.01U.141.162 | V6 | 2015.04
User Manual
Carephone 62
TeleAlarm
Advertisement
Table of Contents
