Slideout Emergency Retraction (Lippert) - Winnebago Sunova Operator's Manual

Crank-In Procedure
1. Disengage the motor brake, which appears as
a flat "square" protrusion on the protective
boot at the end of the motor. Move the brake
lever slightly - about 1/8 turn counter-
clockwise, or to left when facing end of motor
(repeat for motor at other end of room, if
equipped).
2. Disconnect the motor power lead from the
wiring harness (repeat for motor at other end
of room, if equipped).
3. Use a 3/4" socket and ratchet wrench on the
motor gearbox shaft to crank the room in to
the travel position.
3) Use 3/4"socket on gearbox
shaft to crank room in
2) Disconnect
motor power lead
from wiring harness
Slideout Motor/Gear Assembly
(Located beneath end of slideout room rail)
* Shown with slideout room extended
-Typical View
NOTE: If equipped with two motor/gearbox
units, crank both sides of the room
alternately and equally to avoid wedging
the room.
If help is available, a second person
(with a duplicate socket and ratchet)
cranking the other end simultaneously
will greatly speed up the process.
4. Crank the room(s) until it is just "snugged up."
Do not over-crank or you could damage the
gear assembly.
1) Lift tab inside
protrusion on boot to
disengage motor brake
SLIDEOUT ROOMS AND LEVELING
5. While maintaining pressure on ratchet
wrenches, re-engage the motor brake by
moving lever clockwise slightly - or to right
when facing end of motor (repeat for motor at
other end of room, if equipped).
6. Reconnect motor power lead to wiring
harness (repeat for motor at other end of room,
if equipped).
7. Fasten slideout room travel latching device (if
equipped) inside the coach before driving the
vehicle.
8. See your dealer for service of the slideout
mechanism before using again.
Further Information
See the Under Floor Slideout Room operating
guide included in your InfoCase for further
instructions and troubleshooting information.
SLIDEOUT EMERGENCY
RETRACTION (LIPPERT)
–If Equipped
If the slideout mechanism is malfunctioning
and the room will not retract using the interior
control switch or exterior control panel, you may
need to access the slideout motors and manually
push the room in to the travel position.
There are two slideout motors equipped on the
end wall of each slideout room. Pull back wipe
seal to access motors.
NOTE: Use caution when removing components
on painted units.
Push-In Procedure
1. Using a razor blade, remove sealant from the
top of screw cover.
SECTION 10 –
10-9