Electrolux EDW 1100 Service Manual page 38

8.3.4. EDW 1503
General information
w Calling the Service Functions is similar with all designs
or key arrangements.
w Always use the keys S0, S1, S2 and S3 independently
from their program assignment depending on the model.
w In service function mode, you can ALWAYS call the Pulse
Wash function by using keys S2 and S3. Use key S2 to
modify the setting.
w From works settings, Pulse Wash is always set to be active.
EDW 1503 / VGA
LD1 LD2 LD3
1 99
S1 S2 S3
w If you deselect Pulse Wash the rot.speeds of the cir-
cul. pump are always increased to "High Pulse Speed".
Water consumption slightly increases.
Extension of time is possible depending on the temperature.
Always applicable:
In order to call the totality of service functions, always first
press the function keys S1 and S3 prior to switching the
appliance on by means of ON/OFF switch S0!
Keep the keys pressed for abt. 4 seconds in order to activate
the function. This procedure is intentionally distinguished
from those for the customer functions.
ATTENTION: In case of reduced key assemblies
be sure to observe Description Page B 1.
Service function / disconnection pulse wash
Calling above-mentioned service function
1. LD1 LD2 LD3
S1 S2 S3
2.
S1 S3
3.
S1 S3
3-4 seconds
LD1 LD2 LD3
4.
S0
S1 S3
display and LED are flashing
LD2
5.
1P
S2 S3
display and LED are flashing
LD2
6.
0P
S2
display and LED are flashing
LD2
7.
1P
S2
LD1 LD2 LD3 LD4
... automatically OFF after 60 sec
... OFF by actuating ON/OFF manually
Calling the function "Switch OFF Pulse Wash"
LD4 LD5 LD6
LD10
LD11
LD12
S4 S5 S6
S0
3. / 4. ... switch on the appliance with ON/OFF switch S0.
S0
all flashing
S0
Switching the Pulse Wash Function on or off:
6. / 7. Any further activation of function key S2 will switch the
Leaving the function
LD5 LD6
Saving the set condition
S0
S0
1. Appliance should be switched off
2. Simultaneously press S1 and S3 and ...
Keep keys S1 and S3 pressed simultaneously until the
3 acknowledging LEDs LD1, LD2 and LD3 are flashing.
( Short-time illumination of LEDs is possible and does not constitute any fault)
5. Simultaneously press S2 and S3 until the acknowledging
LED-LD2 is flashing. LEDs LD1 and LD3 will go dark.
The current status whether Pulse Wash is active or not is
indicated in the display.
1P = Pulse Wash is active
0P = Pulse Wash is switched off
addition alternately on or off.
After the last key pressure of the function key S2 you
can leave the special program as follows.
After 60 seconds all LEDs of the program and option keys
are lit automatically. The indication in the display goes out.
The appliance is in the "prestart" mode again
or
the appliance is switched off by ON/OFF key S0.
The currently valid condition is saved directly after any entry.