Electrolux EDW 1100 Service Manual page 33

8.2.4. EDW 1500 Service function / disconnection pulse wash
General information
w Calling the Service Functions is similar with all designs
or key arrangements.
w Always use the keys S0, S1, S2 and S3 independently
from their program assignment depending on the model.
w In service function mode, you can ALWAYS call the
Pulse Wash function by using keys S2 and S3. Use key S2
to modify the setting.
w From works settings, Pulse Wash is always set to be active.
LD1 S1
1 99
key arrangement
S2
LD2
vertically
LD3 S3
LD1 LD2 LD3
1 99
key arrangement
horizontally
S1 S2 S3
w If you deselect Pulse Wash the rot. speeds of the cir-
cul. pump are alw.increased to "High Pulse Speed".
Water consumption slightly increases.
Extension of time is possible depending on the temperature.
Always applicable:
In order to call the totality of service functions, always first
press the function keys S1 and S3 prior to switching the
appliance on by means of ON/OFF switch S0!
Keep the keys pressed for abt. 4 seconds in order to activate
the function. This procedure is intentionally distinguished
from those for the customer functions.
ATTENTION: In case of reduced key assemblies
be sure to observe Description Page B 1.
Calling above-mentioned service function
1.
LD1
LD2
LD3
flashing
2.
LD1
Keep keys S1/S3
LD2
pressed for abr. 4 sec.
until LD1-LD3 are flashing
LD3
flashing
3.
LD2
LD0
flashing
4.
S1
LD2
LD0
flashing
S0
5.
LD2
LD1 S1
LD2 S2
LD3 S3
... automatically OFF after 60 sec
Calling the function "Switch OFF Pulse Wash"
LD0
S1
S3
S0
LD0
S1
S3
S0
LD0
1P
S2
S0
S3
LD0
0P
S2
S0
LD0
Switching the Pulse Wash Function on or off:
1P
4. / 5. Any further activation of function key S2 will
S2
S0
Leaving the function
LD0
S1
LD0
LD1 S1
Saving the status settings
LD2 S2
LD3 S3
S0
... OFF by actuating ON/OFF manually
1. Simultaneously press S1 and S3 and ...
2. ... switch on the appliance with ON/OFF switch S0.
Keep keys S1 and S3 pressed simultaneously
until the 3 acknowledging LEDs LD1, LD2 and LD3 are flashing.
( Short-time illumination of LEDs is possible and does not constitute any fault)
3. Simultaneously press S2 and S3 until the acknowledging LED
LD2 is flashing. LEDs LD1 and LD3 will go dark.
The current status whether Pulse Wash is active or not
is signaled in the display.
1P = Pulse Wash is active
0P = Pulse Wash is switched off
switch the addition alternately on or off.
After the last activation of function key S2 you can leave the
special program as follows:
After 60 seconds all displays go out automatically, except
LD0 of the ON/OFF key
or
the appliance is switched off by ON/OFF key S0.
Immediately after each input of data, the currently valid status
will be saved.