Mounting On A Ceiling; Connecting Power - 3Com 6000 User Manual

Connecting Power

7

Mounting on a Ceiling

To mount an access point to the T-rail grid of an acoustical ceiling, you must first
attach the mounting bracket to the access point as shown in the following illustration.
Align the T-rail grips with the ceiling T-rail, adjust them so that they grip the T-rail
snugly, and tighten the screws on the T-rail grip. Adjust the antenna so that it
points straight down. Refer to the illustration below.
Connecting Power
The access point is powered by a standard Category 5 unshielded twisted pair
(UTP) Ethernet cable connected to a power brick, eliminating the need to run
standard power directly to the access point. A 35-foot Ethernet cable is supplied
for connecting the access point to the power brick. A female-female Ethernet
connector is also supplied, which you can use if you need to add extra cable. The
power brick can be located at any point between the access point and the LAN
access port (if you plan to connect to a wired LAN), where a convenient power