Mounting The Ap On A Ceiling - 3Com WL-607 Quick Installation Manual

Mounting the AP on a ceiling

Note:
1) To use this installation method, make sure that the thickness of the ceiling is
less than 18 mm (0.71 in), and the ceiling can bear the weight of at least 5 kg
(11.02 lb.).
2) You are not recommended to use this method to mount the AP to a location
made of low-intensity materials such as a plaster ceiling. If this installation
method is required in such an environment, put a high-intensity plate beneath
the nut to secure the installation.
Select the two mounting holes of the wall-mounting bracket as shown in Figure5 to
mount the AP on the ceiling (in mm). Follow these steps to mount the AP on the ceiling:
Step1 Drill two holes in the ceiling corresponding to the two mounting holes in the
wall-mounting bracket.
Figure5 mounting holes on the wall-mounting bracket
(1) Mounting holes for mounting on a ceiling
Step2 Insert the bolts through the mounting holes of the wall-mounting bracket and
the drilled holes on the ceiling, and then tighten the nuts on the other side of
the ceiling to secure the wall-mounting bracket as shown in Figure6.
viii