Aiwa XD-DV290K Service Manual page 9

PICK UP
ASSEMBLY GENERAL
GUIDE FEED PU
BASE PU (OUTSERT)
MOTOR (MECH.)
10. Base Assembly Feed (Fig-10)
1) Disconnect the Connector (C5)
2) Release the Screw (S3).
10-1. Rubber R
10-2. Spring Skew
1) Press the (A) position of the Spring Skew and unlock
the Spring Skew locking.
10-3. Shaft PU Main
10-4. Shaft PU SUB
Note: When reassembling, be careful not to change the
Shaft PU Main (Long) and the Shaft PU Sub (Short).
10-5. Mechanism Assembly PU Unit
10-5-1. Guide Feed PU
1) Release the Screw (S4) and separate the Guide Feed PU
from the Pick up Assembly General.
10-5-2. Spring Guide Feed
MOTOR ASSEMBLY PU FEED
BASE PU (OUTSERT)
SHAFT PU SUB
(C5)
SPRING
GUIDE FEED
(S4)
SPRING SKEW
(S5)
(S5)
CABLE FLEXIBLE
SHAFT PU MAIN
(S3)
RUBBER R
(L4)
(A)
(L3)
(A)
Fig-10
10-5-3. Pick Up Assembly General
10-6. Motor (mech.)
1) Release the 3 Screws (S5) at bottom side.
2) Push down the Motor (Mech.) and separate from the
Base PU (Outsert).
10-7. Shaft Lead Screw
1) Push the Shaft Lead Screw in direction on arrow (A) a
little and lift up the Shaft Lead Screw.
10-8. Motor Assembly PU Feed.
1) Unlock the Locking tab (L3) and lift up the P.C.Board.
2) Unlock two Locking Tabs (L4) and push down the
Motor Assembly PU Feed.
3) Separate the Motor Assembly PU Feed from the Base
PU (Outsert).
Note: When reassembling, place the Motor Assembly PU
Feed as Fig-(A) and insert the Cable Flexible to the
Hole (A) of the Base PU (Outsert). (See Fig-(A))
10-9. Motor (mech.)
9
(A)
Fig-(A)
P.C. BOARD
RED
BLACK
MOTOR
ASSEMBLY PU
FEED
SHAFT LEAD SCREW