Aiwa XD-DV290K Service Manual page 8

DECK MECHANISM ASSEMBLY
(L1)
(L1)
(C2)
(S1) (S1)
BRACKET CLAMP
CLAMP
PLATE CLAMP
ASSEMBLY DISK
MAGNET CLAMP
CLAMP LOWER
(S2)
7. Junction C.B (Fig-7)
1) Put the Deck Assembly face down. (Bottom side)
2) Release 4 Screws (S1).
3) Unlock 4 Locking tabs (L1).
4) Lift up the Junction C.B a little to disconnect the
Connector (C1).
5) Disconnect 3 Connectors (C2, C3, C4).
DECK ASSEMBLY
(L1)
(L1)
(C4)
(C3)
JUNCTION
C.B
(C1)
(S1) (S1)
Fig-7
(A)
(S2)
BRACKET CLAMP
DECK ASSEMBLY
Fig-8
TRAY DISK
EMERGENCY
EJECT HOLE
8. Bracket Assembly Clamp (Fig-8)
1) Put the Deck Assembly on original position. (Top side)
2) Release 2 Screws (S2).
3) Lift up the Bracket Assembly Clamp.
8-1. Clamp Assembly Disk
1) Place the Clamp Assembly Disk as Fig-(A).
2) Lift up the Clamp Assembly Disk in direction of arrow
(A).
3) Separate the Clamp Assembly Disk from the Bracket
(Fig-A)
Clamp.
8-1-1. Plate Clamp
1) Turn the Plate Clamp to counterclockwise direction and
then lift up the Plate Clamp.
8-1-2. Magnet Clamp
8-1-3. Clamp Lower
8-2. Bracket Clamp
9. Tray Disk (Fig-9)
1) Insert and push a Driver in the emergency eject hole (A)
at the front side, or put the Driver on the Lever (B) of
the Gear Emergency and pull the Lever (B) in direction
of arrow (A) so that the Tray Disk is ejected about 15-
20mm.
2) Pull the Tray Disk until the moving is locked by the
Locking Tab (L2).
3) Unlock the Locking tab (L2) in direction of arrow (B).
4) Separate the Tray Disk completely.
8
(B)
(L2)
(B)
(A)
(A)
BOTTOM SIDE VIEW
Fig-9
LEVER