Telematrix SP-300 Spectrum PLUS User Manual page 6

Single line feature phone
Hide thumbs Also See for SP-300 Spectrum PLUS:
Table of Contents

Advertisement

DOC - NOTICE AND LOAD NUMBER STATEMENT
NOTICE: The Canadian Department of Communications label identifies certified equipment. This certification means that the
equipment meets certain telecommunications network protective, operational and safety requirements. The Department does
not guarantee the equipment will operate to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecom-
munications company. The equipment must also be installed using an acceptable method of connection. In some cases, the
company's inside wiring associated with a single line individual service may be extended by means of a certified connector
assembly (telephone extension cord). The customer should be aware that compliance with the above conditions may not pre-
vent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by the supplier.
Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications
company cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and
internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural
areas.
Caution: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspec-
tion authority, or electrician, as appropriate.
The Load Number (LN) assigned to each terminal device denotes the percentage of the total load to be connected to a tele-
phone loop, which is used by the device, to prevent overloading. The termination on a loop may consist of any combination of
devices subject only to the requirement that the total of the Load Numbers of all the devices does not exceed 100. An alpha-
betic suffix is also specified in the Load Number for the appropriate ringing type (A or B), if applicable. For example, LN = 20 A
designates a Load Number of 20 and an "A" type ringer.
NOTIFICATION TO THE TELEPHONE COMPANY
Before you may connect your telephone you must notify the telephone company of particular line(s)to which such connec-
tions is to be made, and provided to the telephone company the FCC registration number and ringer equivalence number of
the registered protective circuitry. The customer shall give notice to the telephone company upon final disconnection of such
equipment or circuitry from the particular line(s).
Malfunction Of Telephone
In the event that your telephone fails to work properly during your ownership and use of it, you should disconnect it from the
telephone line to determine if it is your phone that is not working properly or if it is a problem in the telephone company's net-
work. If the problem is with your telephone you should discontinue its use until it is repaired.
Telephone Connection Requirements
Except for telephone company- provided ringers, all connections to the telephone network shall be made through standard
telephone company provided jacks, in such a manner as to allow for easy and immediate disconnection of the terminal
equipment. Standard jacks shall be so arranged that if the plug connected thereto is withdrawn, no interference to the opera-
tion of the equipment at the customer's premises which remains connected to the telephone net work shall occur by reason
of such withdrawal. These telephones may not be used on party lines or coin operated lines.
Changes In Telephone Company Equipment Or Facilities
The telephone company is entitled to make changes in its facilities equipment, operations, and procedures. Should these
changes be expected to render your terminal equipment incompatible with the telephone company's facilities you will be
given sufficient notice to allow you to make the necessary modification to your terminal equipment without any interruption of
your service.
6

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SP-300 Spectrum PLUS and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Spectrum plus sp-200

Table of Contents