Elation DLED Par Zoom Manual page 33

2. Press [ENTER], the display shows " RE.XX" , " XX" stands for the number from 1 to 400.
3. Press [ENTER] to confirm or Press [MENU ] to return to the main menu.
Memory Statistics:
Quick Access Programs (Program Part): 3
Total Number of Programs: 10
Maximum Number of Steps (Scenes) per a Program: 64
Total Number of Scenes (Steps): 250
Step 1 – Building Scenes via Fixture Control Board.
The control will store a maximum of 48 scenes. These scenes are then used to create the
programs. A program can store one or a maximum o f 48 scenes. Keep in mind that a scene
can only be access when it is stored in a " Program." If you wish to build a static scene (a
scene consisting of no movement) for a logo or gobo projection, the scene must be stored
inside a program. To build a scene follow the instructions below:
- Editing the channels of the individual scenes
1. Select " SC01" by pressing [UP] or [DOWN] button.
2. Press [ENTER], the display shows " SCXX" , " X" stands for the scene no. to be
edited.
3. Change the scene no. by pressing [UP] or [DOWN] button.
4. Press [ENTER], the display shows " C-X" , " X" stands for the channel no. Such as
" C-01" , it means you are editing channel 1 of the selected scene.
5. Select the channel no. you would like to edit by pressing [UP] or [DOWN] button.
6. Press [ENTER] to enter editing for the selected channel, the fixture reacts to your
settings. The display shows the DMX value of the edited channel. Such as " 11XX" , it
stands for in the channel 11 of the editing scene, the DMX value is XX , XX is a
hexadecimal number value " 01-FF" .
7. Adjust the desired DMX value by pressing [UP] or [DOWN] button.
8. Press [ENTER] in order to edit other channels of this scene.
9. Repeat steps 5 -9 until you finish setti ng all the DMX values for all channels of this
scene.
10. Once all the channels completed, the display will flash " TIME"
©Elation Professional, Los Angeles Ca. 32
DLED Par Zoom
www.ElationLighting.com
™