Elation DLED Par Zoom Manual page 22

Remarks:
1) If the fixture does not receive a DMX signal the menu display will flash
repeatedly.
2) TIME: Adjust the hold time for each scene in built-in chase programs.
3) FADE: Adjust the fade time between each scene in the built-in programs.
9.1 "MODE" - Function Mode:
9.1.1 <ADDR> - DMX address setting – This function is used to set or adjust the
fixture' s starting DMX address. E very device controlled by DMX has to have a unique
starting address. The addressing feature is what allows DMX to function properly. The
DMX address of a fixture is what allows it to communicate with a controller properly. The
DMX addressing also allows the fixture to ignore any DMX information coming from the
controller that is not meant specifically for the fixture. Because each fixture is connected
in a daisy-chain fashion it is imperative to assign a proper and unique starting DMX
address to each and every fixture. The DMX address is non-destructive and will remain
in the fixture' s memory even when the power to the unit is switched off. Memory is
backed-up and retain by an internal power source that should last about five years. For
proper DMX addressing see " DMX Addressing" on page 26 of this user manual.
" VALU" - DMX address
The function will display the current DMX address. . For proper DMX addressing see
" DMX Addressing" on page 26 of this user manual.
" SLAV" - Slave setting for Master/Slave Operation
With this function, you can define the device as slave for operation in Master/Slave
mode. Each slave setting will have a different function for a dynamic lightshow
without a controller.
" RDMX" - Address via DMX - This function allows the DMX address to remotely be
adjusted from a DMX console. This setting requires special settings for both the
controller and the fixture. RDMX is on by default. For operational instructions please
see Section 10/Page 26 of this manual " Remote DMX addressing."
©Elation Professional, Los Angeles Ca. 21
DLED Par Zoom
www.ElationLighting.com
™