Elation DLED Par Zoom Manual page 24

9.2 " SET" – Fixture Personality Settings:
These functions set specific running modes and operating parameters.
<MIC> Microphone Sensitivity
This function adjusts the sensitivity of the built-in microphone. The fixture uses the
built-in microphone to trigger the built-in programs to sound.
<FAIL> DMX Fault Protection
This function dictates how the fixture will operate in the event DMX signal is suddenly
lost while operating in DMX mode. The four fail safe modes are; 1) " OFF" which will
blackout all light output, 2) " HOLD," which will hold the last DMX command, 3) " A UTO,"
which will put the fixture in sound -active mode, or 4) " SOUN" which is sound active.
<REST> Reset Function
This function resets the zoom motor and returns the motor to the " home" (starting)
position. Use this function in the event the zoom motor was physically bumped out of
place.
<DFSE> - Restore Default
This function is used to restore the factory settings of the device. All settings will be set
back to the default va lues (shaded). Any edited scenes will be lost.
<POHO> - Power on to preserve the MANL settings
This function will preserve all the manual setting that are made in the " MANL" menu
section. If this function is not activated all manual settings will be lost once the fixture is
tuned off.
<VER> Software Version
This function will display the current firmware version.
9.3 " MANL" – Manual Fixture Settings:
This function allows the each of the eight DMX channels to be controlled manually. This
will allow the fixture to be preset to a specific color or built-in program without the use of
a DMX console.
©Elation Professional, Los Angeles Ca. 23
DLED Par Zoom
www.ElationLighting.com
™