Elation DLED Par Zoom Manual page 11

2. LED Lens Assembly – The lens assembly may be user replaced in the event repair
is needed or a different beam angle is required.
3. Yoke Assembly – This yoke is designed to perform two functions; 1) When split it
can be used as a floor stand. 2) Used to secure a mounting clamp for truss mounting.
4. MENU Button – This button is used to access the fixtures menu functions.
5. Up Button – The up button is used to toggle forward through the menu functions and
settings.
6. Down Button – The down button is used to toggle backwards through the menu
functions and settings.
7. Enter Button – The enter button is used to enter in to a certain menu function or to
lock a menu setting in to memory.
8. Main Power Input– This power assembly provides main power to the unit and also
houses the intergraded safety fuse. Be sure to always use an approved power rated
IEC cable to feed power to the unit. In the event of fuse failure, always replace with
the exact same fuse unless otherwise instructed to do so by an authorized Elation
technician.
9. DMX Out Jack – 3-pin Male XLR connector. This lead is used to send an incoming
DMX signal to the next fixture in the DMX chain. Always use a proper DMX cable for
data transfer
10. DMX In Jack – 3-pin Female XLR connector. This lead is the main DMX input lead.
Always use a proper DMX cable for data transfer
©Elation Professional, Los Angeles Ca. 10
DLED Par Zoom
www.ElationLighting.com
™