Operation - ADJ Inno Pocket Roll User Instructions

Inno Pocket Roll
5-Pin XLR DMX Connectors.
512 data cables for DATA transmission in place of 3-pin. 5-pin DMX
fixtures may be implemented in a 3-pin DMX line. When inserting stan-
dard 5-pin data cables in to a 3-pin line a cable adaptor must be used,
these adaptors are readily available at most electric stores. The chart
below details a proper cable conversion.
3-Pin XLR to 5-Pin XLR Conversion
Conductor 3-Pin XLR Female (Out)
Ground/Shield
Data Compliment (- signal)
Data True (+ signal)
Not Used
Not Used
ADJ Products, LLC - www.adj.com - Inno Pocket Roll Instruction Manual Page 7
Set Up
Some manufactures use 5-pin DMX-
5-Pin XLR Male (In)
Pin 1 Pin 1
Pin 2 Pin 2
Pin 3 Pin 3
Pin 4 - Do Not Use
Pin 5 - Do Not Use
Inno Pocket Roll
Show Mode:
This mode allows either a single unit or several units
linked together, to run one of 12 shows that you choose. Show mode
can run with or without sound active mode.
1. Press the MENU button until "SHND" is displayed, and press
ENTER.
2. Press the UP or DOWN buttons until you find your desired show,
press ENTER, then press and hold the MENU button for at least 3
seconds to activate. After you have set your desired show, it can
be changed at any time using the UP or DOWN buttons.
Inno Pocket Roll
Master-Slave Configuration
to 16 units together and operate without a controller. The units will be
sound activated. In a Master-Slave set up, one unit will act as the con-
trolling unit and the others will react to the controlling units programs.
Any unit can act as a Master or as a Slave.
1. Using approved DMX data cables, daisy chain your units togeth-
er via the XLR connector on the rear of the units. Remember the
Male XLR connector is the input and the Female XLR connector
is the output. The first unit in the chain (master) will use the female
XLR connector only - The last unit in the chain will use the male
XLR connector only. For longer cable runs we suggest a termina-
tor at the last fixture.
2. Set the Master unit to your desired operating mode.
3. On the slave units tap the MENU button until "SLND" is dis-
played, and Press ENTER. Choose either "SL 1" or "SL 2" and
press ENTER. See page 9 for more info.
4. The slave units will now follow the Master unit.
Inno Pocket Roll
With this feature you can connect the fixtures to one another
using the IEC input and output sockets. The quantity that can be
connected is 19 fixtures maximum for 120V and 35 fixtures maxi-
mum for 240V. After the maximum fixtures has been reached you
will need to use a new power outlet. They must be the same fix-
tures. DO NOT mix fixtures.
ADJ Products, LLC - www.adj.com - Inno Pocket Roll Instruction Manual Page 16

Operation

Master-Slave Set Up
This function will allow you to link up
Power Cord Daisy Chain