Operation - ADJ MICRO 3D II User Instructions

Micro 3D II
1. Status Light - This LED Indicates which operating mode is
active.
2. Mic - This mic picks up the beat of the music in sound active
mode.
3. Mic Sensitivity - Use a small screwdriver to adjust the sound
sensitivity.
4. IR Sensor - Receives the signal from the included UC Laser
IR.
5. Mode Button - Press this button to switch operating modes.
6. ON/OFF Button - Press this button to switch the power ON
and OFF.
7. Power LED - Indicates that power is activated.
8. DC12V Input - DC Power Socket for included power adapter.
ADJ Products, LLC - www.adj.com - Micro 3D II Instruction Manual Page 8
Overview Micro 3D II
CAUTION IMPORTANT! When installing this projector, make sure
that it is mounted in a manner that prevents the audience from
looking directly into the beam, and the beam from striking the
audience.
Operating Modes: The Micro 3D II has 2 operating modes;
sound active mode and auto mode.
Sound Active Mode:
the music.
1. Press the Mode button until the red LED located on the front
of unit turns off. You are in sound active mode if the red LED
on the front of the unit flashes at every beat or sound.
Auto Mode:
mode or fast auto mode.
1. To run fast auto mode, press the Mode button until the red
LED located on the front of unit starts to flash quickly. This
indicates fast auto mode.
2. To run slow auto mode, press the Mode button until the red
LED located on the front of unit starts to flash slowly. This
indicates fast auto mode.
ADJ Products, LLC - www.adj.com - Micro 3D II Instruction Manual Page 9
This mode allows the unit to run to the beat of
There are two auto modes to choose from; slow auto

Operation