ADJ Inno Pocket Roll User Instructions page 10

Inno Pocket Roll
ADDR -
DMX Address Setting.
1. Press the MENU button until "ADDR" is displayed, press
ENTER.
2. The current address will now be displayed and flashing.
Press the UP or DOWN buttons to find your desired address.
When you have found your desired DMX address press ENTER
then press and hold the MENU button for at least 3 seconds to
set your desired DMX address.
3. Connect your DMX Controller.
SLND -
This will let you set unit as a slave in a master-
slave configuration.
1. Press the MENU button until "SLND" is displayed, press
ENTER. Either "SL 1" or "SL 2" will be displayed.
2. Press the UP or DOWN buttons until your desired setting is
displayed, and press ENTER to confim.
NOTE: In a Master/Slave configuration you can set one fixture
to Master and then set the next fixture to "SL 2", the fixtures
will now have contrast movement to each other.
SHND: SH 0 - SH12
programs). Show mode can run with or without sound
active mode active.
1. Press the MENU button until "SHND" is displayed, press
ENTER.
2. "Sh X" will now be displayed, "X" representing a number
between 0-12. Programs 1-12 are factory programs, while "Sh
0" is random mode. Press the UP or DOWN buttons to find your
desired show.
3. When you have found your desired show press ENTER, then
ADJ Products, LLC - www.adj.com - Inno Pocket Roll Instruction Manual Page 9
System Menu
- Show modes 0-12 (Factory
Inno Pocket Roll
To enter the offset adjustment submenu, press the ENTER button for
at least 5 seconds. In this submenu you are able to adjust the pan
home position and gobo wheel position.
PAN
- Adjustment of the pan position.
1. Press the ENTER button for at least 5 seconds, then press the UP
or DOWN buttons so that "PAN" is displayed, press ENTER.
2. Use the UP and DOWN buttons to make your adjustments, and
then press ENTER to confirm. Press the MENU button for one second
to exit.
GOBO
- Adjustment of the gobo position.
1. Press the ENTER button for at least 5 seconds, then press the UP
or DOWN buttons so that "GOBO" is displayed, press ENTER.
2. Use the UP and DOWN buttons to make your adjustments, and
then press ENTER to confirm. Press the MENU button for one second
to exit.
ADJ Products, LLC - www.adj.com - Inno Pocket Roll Instruction Manual Page 14
Offset Adjustment Menu