Powering On The Sat-Fi - Globalstar Sat-Fi Installation And Configuration Manual

Powering on the Sat-Fi

The Sat-Fi automatically powers on when it is connected to a power source. The single push button in
the front acts as a hard power reset switch allowing the Sat-Fi to be easily restarted without having to
physically disconnect the power. Once powered on the Sat-Fi performs the following sequence:

Automatically boots

Enables the Wi-Fi

Attempts to register with the Globalstar Satellite Network
This process may take up to 30 seconds to complete.
The LED on the front panel provides a visual indication of the Sat-Fi's status:

ON (Solid) – The Sat-Fi is registered with the Globalstar Satellite Network and is able to
send/receive calls and data

Fast Blinking – The Sat-Fi is searching for service and/or registering with the Globalstar Satellite
Network

Slow Blinking – The Sat-Fi is in use; either sending/receiving a call or data transmission

OFF – The Sat-Fi is powered off and not connected to a power source
Sat-Fi Installation & Configuration Guide Page 11