Resetting And Registering Handsets - Uniden XDECT 7015WP Series Owner's Manual

Here are some hints for when the static is...
on 1 handset or in 1 location:
- Check nearby for one of the common
interference sources.
- Try moving the handset away from a
suspected source, or try moving the
suspected source so it's not between the
handset & the base.
- Try moving closer to the base. There is
always more noise at the edges of the
base's range. If the handset displays an
Out of Range message, you need to
move closer to the base.
Installing a line filter or DSL filter
Sometimes, broadband Internet services
that use the telephone line can interfere
with phones. One of these services -DSL-
often causes static on telephones. A DSL
filter or telephone line filter usually solves
this problem. The technician who installed
your DSL service might have left some
filters for you; if not, call your DSL provider or look in any electronics
store. Plug the DSL filter into the telephone wall jack and plug your
phone's base into the filter. Make a test call to make sure the noise is
gone.

resetting and registering Handsets

If you are having trouble with a handset or if you want to replace one,
you need to clear the registration information from the base and the
handset:
Do you have the base the handset is registered to?
1. Press & hold
System Reset menu appears (about 5
seconds).
2. Select Deregister HS. The display lists
all registered handsets.
3. Select the handset you want to reset.
4. When the phone asks you to confirm,
select Yes. The handset clears its
information from the base & deletes it
own link to the base.
20
Yes
and until the
END ( ) #
on all handsets or in all locations:
- Check near the base for the source
of interference.
- Try moving the base away from a
suspected source, or turn off the
source if possible.
- If the base has an adjustable
antenna, try raising the antenna so
it stands straight up.
- If you have any service that uses
the phone line, you might need a
filter (see below).
Telephone
cord
1. Press & hold
until the System Reset menu
appears (about 5 seconds).
2. Select Base Unavailable.
3. When the phone asks you
to confirm, select Yes. The
handset deletes its own link
without contacting the base.
Telephone
wall jack
DSL filter
No
and
END ( ) #