Connect The Telephone Cord; Using The Belt Clip - Uniden XDECT 7015WP Series Owner's Manual

Connect the Telephone Cord

Use the telephone cord to connect the
telephone wall jack.
Test the connection
11 Pick up the handset from the cradle and press
should hear a dial tone, and the display should say Talk.
If...
you don't hear a dial tone or the
display says Check Tel Line
21 Make a quick test call. (Press
If...
there's a lot of noise or static
31 Test any accessory handsets the same way. If you can't get a
dial tone or the handset display says Unavailable, try moving the
handset closer to the base or resetting it (see page 20). Charge
all handsets completely (about 16 hours) before using them.

Using the Belt Clip

To attach the belt clip
Line up the holes on each side of the handset. Insert the belt clip into
the holes on each side of the handset. Press down until it clicks.
To remove the belt clip
Pull either side of the belt clip to release the tabs from the holes.
4
TEL LINE
Try...
checking the connection between
the base and the phone jack.
to hang up.)
END ( )
Try...
see page 19 for tips on avoiding
interference.
jack to a standard
TaLK ( )/FLaSH
. You