Test Print - Oki C710 Maintenance Manual

Oki Data CONFIDENTIAL

5.3.1.5 Test print

This self-diagnostic menu is used to print the test pattern that is built inside PU. Other test
patterns are stored in the controller.
This test print cannot be used to check the print quality.
Diagnosis for the abnormal print image should be performed in accordance with section 7.
1. Enter the self-diagnostic mode (level 1) and keep pressing the MENU+, MENU-
key until "TEST PRINT" is displayed in the upper row of the display area. Then,
press the ENTER key. (Pressing the MENU+ key increments the test item and
pressing the MENU- key decrements the test item.)
2. The setting items that can be applied to the test print only is displayed in the
lower row of display area. Keep pressing the MENU+, MENU- key until the
desired menu item is displayed. (Pressing the MENU+ key increments the test
item and pressing the MENU- key decrements the test item.) (If all setting items
need no entry [Default setting], go to step 5.)
3. Keep pressing the MENU+, MENU- key, and press the ENTER key at the menu
item set by step 2. Then, the setting item is displayed in the upper row of display
area, and the setting value is displayed in the lower row of display area.
Pressing the MENU+ key increments the setting value. Pressing the MENU+
key decrements the setting value. (The setting value that is displayed at last is
applied.) Pressing the BACK key determines the entry value, and returns to step
2. Repeat step 3 as required.
TEST PATTERN
1
43856301TH Rev.3
Display Setting value
PRINT EXECUTE –
TEST PATTERN 0
TEST CASSETTE TRAY1
TRAY2
TRAY3
MFP
PAGE 0000
COLOR ON
OFF
DUPLEX 2 PAGES STACK
OFF
1PAGES STACK
• is the initial default value. The menu item that is set here is valid in this menu
item only.
(The setting item is not saved in EEPROM.)
Note! PAGE setting
Pressing the MENU+ key or the MENU- key shifts the digit. Pressing
the ONLINE key increments the setting value. Pressing the MENU+ key
increments the setting value. If print is executed while the number of print
copies remains in "0000", printing will continue infinitely.
COLOR setting
When the ENTER key is pressed while ON is set, the following contents
are displayed on the panel.
Print setting for each color
Pressing the MENU+ key or the MENU- key shifts the setting. Pressing
the ONLINE key or the CANCEL, the ON/OFF switchover will be set.
Pressing the BACK key returns the panel display.
COLOR
ON
5. Maintenance Menu
Function
Pressing the ENTER key starts print/Pressing the
CANCEL key terminates print. (In units of page)
0: White paper print
1~7: Refer to next page. (Pattern print)
8~15: White paper print
Selecting source of paper supply.
If the TRAY 2 is not installed, TRAY2 is not
displayed.
If the TRAY 3 is not installed, TRAY3 is not
displayed.
Setting number of the test print copies
Selecting either color/monochrome print
* When ON is specified, ON/OFF setting for each
color becomes available.
Duplex (2-sided) print is performed by the stack of
two sheets of paper.
Selecting OFF for duplex (2-sided) print.
Duplex (1-sided) print is performed by the stack of
one sheet of paper.
Y:ON M:ON
C:ON K:ON
102 /