Guide Eject Assy/ Color Resist Assy/ Board-Pry - Oki C710 Maintenance Manual

Oki Data CONFIDENTIAL

4.2.16 Guide eject Assy/ Color resist Assy/ Board-PRY

(1) Remove the left side cover, right side cover, rear cover, top cover Assy. (See
section 4.2.3, 4.2.4, 4.2.6, 4.2.10 )
(2) Remove the print engine controller PCB, control PCB and low-voltage power
supply. (See section 4.2.8, 4.2.9, 4.2.15(3))
(3) Remove the connector of belt thermistor, remove the two torsion springs
disengage four claws (4 places) by minus driver, remove the cover driver
(4) Remove the screws (silver) and connectors (6 places), remove the Board
PRY .
(5) Remove the two screws
(6) Remove the two screws
from clamp, and slide the claw of cable guide
eject Assy .
43856301TH Rev.3
(silver) and remove the color resist Assy
(silver), remove the cable of fuse I/F connector
to disengage, remove the guide
, and
.
.
4. Component replacement
Claw
Claw
DENS
RCR
FUSER
LCR
74 /