Lincoln Electric CLASSIC I SVM134-A Service Manual page 86

F-42
MIDDLE SCREW (1)
23. Using the 1/2" wrench, remove the two bolts,
nuts, and washers that hold the front panel
assembly to the horizontal rails. (There is
one on each side.) See Figure F.20.
24. Using the 9/16" wrench, remove the four
bolts, nuts, and washers from the bottom of
the front panel assembly. These four bolts
mount the front to the base. (There are two
on each side.) See Figure F.20.
TROUBLESHOOTING & REPAIR
MAIN GENERATOR FRAME REMOVAL
AND REPLACEMENT (continued)
FIGURE F.20 – FRONT PANEL FASTENER REMOVAL
CLASSIC I
BOLTS / NUTS / WASHERS (2)
BASE MOUNTING BOLTS (4)
25. Using the 3/8" nut driver, remove the screw
from the lower middle of the front panel. See
Figure F.20.
26. Carefully remove the front panel assembly.
F-42