Mounting The U-Bracket - Tait TM8100 Installation Manual

Hide thumbs Also See for TM8100:

Table of Contents

3.3

Mounting the U-Bracket

The U-bracket can be used to install the radio on the dashboard or on any

sufficiently flat surface (e.g. cabin floor or trunk). The U-bracket can be

mounted using the self-drilling screws and washers provided in the

installation kit, or nuts and bolts (not included).

Figure 3.3

TM8100/TM8200 Installation Guide

Caution Although an industrial-strength recloseable fastening system

can be used to support the installation, for safety reasons Tait does not

recommend this as a mounting option.

Notice When mounting the radio on a surface, check whether the

mounting screws will screw into material providing sufficient strength.

Reinforce the mounting surface, if required.

If the U-bracket is being mounted over a curved surface, bend the

tabs at the bottom of the U-bracket slightly to match the surface

shape.

Hold the U-bracket in the position chosen for the radio and use the

mounting holes as a template to mark the mounting locations.

Use at least four screws to install the U-bracket.

The screws provided are self-drilling. For more precise positioning, pre-

drill ∅1/8 inch (3 mm) pilot holes for self-drilling screws. Reduce the

hole size in metal that is less than 1/32 inch (1mm) thick.

Notice Ensure that drilling at the selected points will not damage

existing wiring.

Drill any holes required for cables and install suitable grommets or

bushings in the holes.

Screw the U-bracket in the chosen mounting position using the self-

drilling screws and washers provided. When tightening the screws,

ensure that this does not distort the U-bracket.

Mounting the U-bracket

Installing the Radio

Table of Contents

Tm8200