Specifications; Maintenance And Repairs - Stihl HL-KM Instruction Manual

Definitions
1 Cutting Blades
Steel blades for cutting hedges and
shrubs.
2 Blade Drive Gear
Converts rotary movement of angle
drive into reciprocating movement
of cutting blades.
3 Angle Drive
Transmits rotary motion of drive
shaft to the blade drive gear.
4 Drive Tube
Encloses and protects the drive
shaft between the coupling sleeve
and gearbox.
5 Sliding Sleeve
Locks and unlocks the cutter bar
adjusting mechanism.
6 Adjusting Lever
Used to set cutter bar to the
required angle.
7 Quadrant
Locks the cutter bar in the required
position.
8 Blade Scabbard
Covers cutting blades when hedge
trimmer is not in use.
HL-KM

Specifications

Cutting Blades
Type: Double-edged for
bidirectional cutting
Cutting length: 500 mm (19.685 in.)
Tooth spacing: 35 mm (1.378 in.)
Tooth height: 20 mm (0.787 in.)
Sharpening
angle: 45° to horizontal
Weight
HL-KM 0°: 1.8 kg (4.0 lbs.)
HL-KM 135°: 2.6 kg (5.7 lbs.)

Maintenance and Repairs

Users of this unit should carry out only
the maintenance operations described
in this manual. STIHL recommends that
other repair work be performed only by
authorized STIHL servicing dealers.
Warranty claims following repairs can be
accepted only if the repair has been
performed by an authorized STIHL
servicing dealer using genuine STIHL
replacement parts.
Genuine STIHL parts can be identified
by the STIHL part number, the
{ logo and, in some cases, by
the STIHL parts symbol K. The
symbol may appear alone on small
parts.
English
19