Specifications - Stihl FSA 200.0 Instruction Manual

English
Fault LEDs on the
battery
The brushcutter 3 LEDs light
cuts out during up steady red.
operation.
The runtime of
the brushcutter is
too short.
The power levels
cannot be set.
The STIHL con‐
nected app is
unable to find the
battery with .
20.2 Product Support and Assis‐
tance on Use
Product support and assistance on use are avail‐
able from STIHL servicing dealers.
For contacts and other information, please visit
https://support.stihl.com or www.stihl.com.

21 Specifications

21.1 STIHL FSA 200.0 Brushcutters
– Permitted batteries:
– STIHL AP
– STIHL AR
– Weight without battery, cutting tool and deflec‐
tor: 5.7 kg
– Length without cutting tool: 1805 mm
– Degree of protection: IPX4 (protection against
splash water from any direction)
For runtime, see www.stihl.com/battery-life.
21.2 STIHL AP battery
– Battery technology: lithium-ion
– Voltage: 36 V
– Capacity in Ah: see rating label
50
Cause
The brushcutter or
battery is damp.
Trigger is pressed
before operating the
unlock button.
The brushcutter is too
hot.
There is an electrical
fault.
The battery is not fully
charged.
The battery service
life has been excee‐
ded.
The trigger is pressed
and the brushcutter
switched on.
®
The Bluetooth radio
interface on the bat‐
tery or mobile device
is deactivated.
Excessive distance
between the battery
and the mobile
device.
– Energy content in Wh: see rating label
– Weight in kg: see rating label
– Bluetooth
with
– Data connection: Bluetooth
– Frequency band: ISM band 2.4 GHz
– Maximum RF power transmitted: 1 mW
– Signal range: approx. 10 m. The signal
– Mobile appliance operating system require‐
Remedy
► Allow the brushcutter or battery to dry,
21.4.
► Switch on the brushcutter as described in
this User Manual.
► Remove the battery.
► Allow the brushcutter to cool down.
► Remove the battery and reinsert it.
► Switch on the brushcutter.
► Recharge the battery fully as described in
the User Manual for the STIHL AL 101,
301, 301-4, 500 chargers.
► Replace the battery.
► Release the trigger and hold only the trig‐
ger lockout pressed.
► Select the power level as described in
this user manual.
► Activate the Bluetooth
the battery or mobile device.
► Reduce distance,
► If the battery still cannot be found with
the STIHL connected app: Contact a
STIHL authorized dealer for assistance.
®
radio interface (only for batteries
):
mobile appliance must be compatible with
®
Bluetooth Low Energy 5.0 and support
Generic Access Profile (GAP).
strength depends on the ambient conditions
and the mobile terminal. Signal range can
vary greatly depending on local conditions,
including the receiver. The range may be
perceptibly reduced inside enclosed rooms
and through metal barriers (such as walls,
shelves or cases).
ments: Android or iOS (current version or
higher)
21 Specifications
®
radio interface on
21.2.
®
5.1. The
0458-040-9601-A