Page 22
STIH) STIHL KM 110, 130 Instruction Manual Manual de instrucciones Warning! Read and follow all safety precautions in Instruction Manual - improper use can cause serious injury. Advertencia! Para su seguridad durante el manejo de este producto, siga siempre las precauciones de...
4-MIX Engine ........15 using your power tool. Fuel ..........15 Fueling ..........16 Contact your STIHL dealer or the STIHL Starting / Stopping the Engine ..17 distributor for your area if you do not Operating Instructions ....20 understand any of the instructions in the Cleaning the Air Filter .....
STIHL illustration. dealer for information and assistance. In the STIHL KombiSystem a number of Example: different KombiEngines and KombiTools Loosen the screw (1) can be combined to produce a power tool.
Note or hint on correct procedure in Have your STIHL dealer show you how those described in this manual, please order to avoid damage to the to operate your power tool. Observe all contact your STIHL dealer for environment.
Page 26
Most of these safety precautions and might be aggravated by strenuous work, created by the engine to the warnings apply to the use of all STIHL check with your doctor before operating operator's hands. An AV system is power tools. Different models may have this machine.
Page 27
This field may Continual and regular with STIHL power tools, their use may, in interfere with some pacemakers. To users should have their hearing checked fact, be extremely dangerous. reduce the risk of serious or fatal injury, regularly.
Page 28
Using the grip, turn the cap firmly Your STIHL power tool uses an oil- to release slowly. Never remove the fuel clockwise as far as it will go (approx. a gasoline mixture for fuel (see the chap- filler cap while the engine is running.
English / USA Screw cap Keep the handles clean and dry at all Warning! times; it is particularly important to keep Warning! them free of moisture, pitch, oil, grease Your power tool is a one-person or resin in order for you to maintain a firm Unit vibrations can cause machine.
Page 30
To reduce the risk of fire and burn injury, chemicals (such as your STIHL dealer check your power keep the area around the muffler clean. unburned hydrocarbons tool and make proper adjustments and...
Page 31
Use of stay clean and need no service or non STIHL parts may cause serious or Warning! maintenance. If you experience loss of fatal injury. Since a muffler with a catalytic converter...
KombiTool instruction manuals. Have of fire, never operate your power tool if such work performed by your STIHL the screen is missing or damaged. servicing dealer only. Remember that the risk of forest fires is greater in hot or dry weather.
English / USA Mounting the Bike Handle The following STIHL KombiTools may be mounted on the KombiEngine KombiTool Purpose FS-KM Brushcutter with mowing head FS-KM Brushcutter with grass cutting blade 1) 2) HL-KM 0/90° Hedge trimmer, adjustable Mounting the Handlebar 1) 2) HL-KM 135°...
Page 34
English / USA Place the secured assembly on the Mounting the Control Handle Fitting the Throttle Cable handle support (8) with the wing Loosen the screw (9). The nut (10) Do not kink the throttle cable or lay screw at the engine side. remains in the control handle (11).
English / USA Adjusting the Throttle Cable A properly adjusted throttle cable is the precondition for correct operation in the full throttle, starting throttle and idle positions. Adjust the throttle cable only after the unit is fully assembled – the control handle must be in the normal operating position.
English / USA Mounting the Loop Handle Loop handle with barrier bar Place the clamp (3) in the loop Loop handle without barrier bar handle (4) and position them both Insert square nuts (1) in the Place the clamp (3) in the loop against the drive tube (5).
The STIHL 4-MIX engine features This engine is certified to operate on gasoil lubrication and must be run on a unleaded gasoline and the STIHL two- fuel mixture of gasoline and engine oil. stroke engine oil at a mix ratio of 50:1.
English / USA Fueling Use only STIHL two-stroke engine oil or Fuel mix ages equivalent high-quality two-stroke Only mix sufficient fuel for a few days engine oils that are designed for use work, not to exceed 3 months of storage.
English / USA Starting / Stopping the Engine Opening the cap Closing the cap STOP- START Raise the grip until it is upright. Fit the cap – grip upright –marks must line up. Turn the cap clockwise as far as stop (approx.
Page 40
English / USA Symbol on slide control h (7) – stop symbol and arrow – to stop the engine, push the slide control in the direction of the arrow on the stop symbol (h) to STOP-O. Starting Procedure Hold down the throttle trigger interlock and squeeze the throttle trigger.
Page 41
English / USA Crank engine until it begins to fire. After no more than five attempts, turn the choke knob to e and continue cranking. As soon as engine runs Blip the throttle trigger so that the slide control moves to the normal run position # and the engine settles down to idle Pull the starter grip slowly with your...
English / USA Operating Instructions If the engine does not start Open the throttle wide. During break-in period Crank the engine several times with If you did not turn the choke knob to e A factory new machine should not be run the starter to clear the combustion quickly enough after the engine began to at high revs (full throttle off load) for the...
English / USA Cleaning the Air Filter Motor Management Adjusting the Carburetor Exhaust emissions are controlled by the design of the fundamental engine parameters and components (e.g. carburation, ignition, timing and valve or port timing) without the addition of any major hardware.
Page 44
English / USA Standard Setting Fine Tuning At high altitudes A slight correction of the setting of the Turn the high speed screw (H) Shut off the engine. high speed screw (H) may be necessary clockwise (leaner) no further than Assemble the KombiTool with the stop until there is no noticeable if engine power is not satisfactory when...
English / USA Spark Arresting Screen in Muffler Tool moves when engine is idling The spark arresting screen is an option that is not fitted in all machines. Turn idle speed screw (LA) slowly counterclockwise until tool stops If the engine is low on power, check moving and then turn the screw the spark arresting screen in the about another 1/2 to 3/4 turn in the...
100 operating hours unfavorable running conditions (mostly authorized by STIHL. Always press or earlier if the electrodes are badly at part throttle etc.) affect the condition of spark plug boot (2) snugly onto eroded.
English / USA Replacing Starter Rope and Rewind Spring Replacing the starter rope Remove the spring clip (3). Remove remaining rope from the rotor and grip. Remove the rope rotor with Move slide control in direction of washer (4) and pawl (5). Tie a simple overhand knot in the c –...
Page 48
English / USA Replacing a broken rewind spring Remove the rope rotor as described under "Replacing Starter Rope and Rewind Spring". The bits of spring might still be under tension and could fly apart when you take them out of the housing.
Page 49
English / USA When the starter rope is fully extended it must still be possible to rotate the rotor another half turn. If this is not the case, the spring is overtensioned and could break. Take one turn of rope off the rotor in such a case.
Have the pickup body in the fuel well ventilated area. tank replaced every year. Dispose fuel properly in accordance with local environmental STIHL recommends that maintenance requirements. and repair work be carried out only by authorized STIHL dealers. Run the engine until the carburetor is dry –...
Spark arresting screen* in muffler Replace All accessible screws and nuts Retighten (not adjusting screws) Check Anti-vibration element Have replaced by dealer Safety labels replace 1) STIHL recommends the STIHL dealer see “Guide to Using this Manual“ KM 110, KM 130...
English / USA Parts and Controls 1 Fuel Filler Cap 2 Carburetor Adjusting Screws 3 Starter Grip 4 Spark Plug Boot 5 Muffler (with spark arresting screen*) 6 Bike Handle 7 Throttle Trigge 8 Slide Control 9 Throttle Trigger Interlock 10 Throttle Cable Retainer 11 Clamp (carrying ring) 12 Fuel Pump...
Page 53
English / USA Definitions Fuel Filler Cap 9. Throttle Trigger Interlock 17. Handle Support For closing the fuel tank. Must be depressed before the Connects the shaft and bike handle. throttle trigger can be activated. Carburetor Adjusting Screws 18. Wing Screw 10.
English / USA Specifications Special Accessories EPA: Power according to ISO 8893: Contact your STIHL dealer for KM 110: 1.34 bhp (1,0 kW) information regarding special The Emission Compliance Period at 7000 rpm (1/min) accessories that may be available for referred to on the Emissions KM 130: 1.90 bhp (1,4 kW)
Users of this unit should carry out only the maintenance operations described in this manual. Other repair work may be performed only by authorized STIHL service shops. Warranty claims following repairs can be accepted only if the repair has been...
You are responsible for presenting your small off-road equipment engine to a Obligations Coverage: STIHL service center as soon as a The U.S. Environmental Protection In the U.S., 1997 and later model year problem exists. The warranty repairs will Agency (EPA) and STIHL Incorporated...
Page 57
This Emission Control Systems replaced by STIHL Incorporated at no used for any warranty maintenance or Warranty shall not cover any of the cost to the owner. Any warranted part...
English / USA For California only: STIHL Incorporated California Exhaust and Evaporative Emissions Control Warranty Statement Your Warranty Rights and Manufacturer’s Warranty You are responsible for presenting your small off-road equipment engine to a Obligations Coverage STIHL Service center as soon as the...
Page 59
DEFECTS WARRANTY PERIOD, see The owner must not be charged for STIHL Incorporated at no cost to the above. A statement in such written diagnostic labor that leads to the owner. instructions to the effect of "repair or...
Where to make a claim for ® EASYSTART HT Plus™ Warranty Service ® OILOMATIC IntelliCarb™ Bring the STIHL product to any ® STIHL Cutquik Master Control Lever™ authorized STIHL servicing dealer and present the signed STIHL warranty card. ® STIHL DUROMATIC Micro™...
Page 61
STIHL SuperCut™ STIHL Territory™ TapAction™ TrimCut™ This listing of trademarks is subject to change. Any unauthorized use of these trademarks without the express written consent of ANDREAS STIHL AG & Co. KG, Waiblingen is strictly prohibited. KM 110, KM 130...
Need help?
Do you have a question about the HL-KM and is the answer not in the manual?
Questions and answers