Connecting To Power - Paradyne BitStorm 2600 IP DSLAM Installation Manual

2. Cabling

Connecting to Power

The BitStorm 2600 can be powered by any AC power source supplying
90–265 VAC at 47–63 Hz.
Procedure
To connect the BitStorm 2600 to a power source:
2-12
1. Insert the supplied power cord into the power socket on the back of the unit.
2. If the BitStorm 2600 is in a rack, dress the power cord to the left and fasten it
to the rail with a cable tie.
3. Connect the other end of the power cord to a grounded AC power source.
4. Make sure the STATUS LED on the front panel is ON (green). See
LEDs.
April 2005
02-17248
Chapter 3,
2600-A2-GN20-50