Table of Contents
Advertisement
Table 2-2. CRX-500 RECEIVER TO PAN AND TILT UNIT
Pan/Tilt
Start
Voltage
Current
120 Vac
0.27 A
24 Vac
1.35 A
220 Vac
0.13 A
2.7.4
Camera Power.
The CRX-500 Series Receivers provide selectable 12 Vdc or 24 Vac
camera power at 0.5 Amp (max.). Models CRX-501 and CRX-510
provide power for one camera.
provide power for two cameras.
Receivers have two boards in the chassis; a mother board and an
expansion board. Both boards have terminal block TB1. Connect
one camera to TB1 on the mother board and the other camera to
TB1 on the expansion board.
The camera power is connected at terminal block TB1 on both the
mother board and the expansion board.
Run
Current
0.18 A
0.90 A
0.09A
NOTE
Make sure the camera, lens, and pan
and tilt for each unit are all connected
to the same board in the CRX-502 or
CRX-520 Receiver.
CAUTION
Make Sure Each Board Is Setup For
The Correct Voltage For The Camera
Connected
To
Damage May Occur.
Paragraph
2.5.2,
Setup.
2-24
20 AWG
Distance
1300 Ft.
275 Ft.
2600 Ft.
Models CRX-502 and CRX-520
Model CRX-502 and CRX-520
It
Or
Equipment
Refer To
Camera
Power
18 AWG
16 AWG
Distance
Distance
2200 Ft.
3500 Ft.
440 Ft.
700 Ft.
4400 Ft.
7000 Ft.
Advertisement
Table of Contents
