Table of Contents
Advertisement
2.7.1.1
Daisy-Chain Wiring.
The CRX-500 Series Receivers can be daisy-chained so multiple
receivers can be controlled from one control point. Ten receivers
can be daisy-chain wired from each output port. The total distance
of the chain is 4000 feet.
CRX-500 Receiver
TB1, Terminal 1 (RX+)
TB1, Terminal 3 (RX-)
TB1, Terminal 2 (Shield)
NOTE
The receive communications should be
terminated when only one receiver is
installed in a system. Jumper W4 is
installed
to
communications.
removed
to
leave
communications open.
NOTE
Terminate the receive communication
on the last receiver in the chain. Install
Jumper W4.
Leave the receive communication open
on all intermediate receivers. Remove
Jumper W4.
DAISY-CHAIN WIRING
2-21
terminate
receive
Jumper
W4
the
receive
to
TB1, Terminal 1 (RX+)
to
TB1, Terminal 3 (RX-)
to
TB1, Terminal 2 (Shield)
is
CRX-500 Receiver
Advertisement
Table of Contents
