Table of Contents
Advertisement
2.5.2
Camera Power Setup.
The Control Receivers provide camera power for 12 Vdc or 24 Vac @ 0.5
Amp (max.) cameras. The camera power is setup on the mother board for
the CRX-501 and CRX-510. If Model CRX-502 or CRX-520 Receivers are
installed, there are two boards in the enclosure for powering two cameras.
The camera power must be setup for each camera. The camera power is
setup on the board the camera is connected to.
Camera
Power
24 Vac
12 Vdc.
Model CRX-502 and CRX-520 Only
Camera
Power
24 Vac
12 Vdc
WARNING
ENSURE POWER IS DISCONNECTED FROM
THE CONTROL RECEIVER.
INJURY
COULD
ELECTRICAL SHOCK.
All Models
Mother Board
Jumpers
W8 and W9
Pos. 1 & 2
Pos. 2 & 3
Expansion Board
Jumpers
W4 and W5
Pos. 1 & 2
Pos. 2 & 3
PERSONNEL
RESULT
DUE
2-9
TO
Advertisement
Table of Contents
