Table of Contents
Advertisement
C. Optional Accessories Requirements
• This appliance may be used with a wall switch, wall
mounted thermostat and/or a remote control.
• To connect optional accessories, the supplied cord as-
sembly should be used. See attached Figure 10.2 for
a wiring diagram for a blower or remote.
Wiring for optional Hearth & Home Technologies approved
accessories should be done now to avoid reconstruction.
Follow instructions that come with those accessories.
• Plug the cord into a convenient outlet.
• Must use cord supplied.
GROUND
TERMINATION
NOTE: IF ANY OF THE ORIGINAL
WIRE AS SUPPLIED WITH THE
APPLIANCE MUST BE REPLACED,
IT MUST BE REPLACED WITH TYPE
105° C RATED WIRE.
NOTE: USE ZIP TIES TO RESTRAIN
THE LOOSE WIRES UNDERNEATH
THE APPLIANCE AND KEEP THEM
AWAY FROM THE BLOWER WHEEL
(FAN BLADES).
ORANGE
(PILOT)
VALVE OPTIONS
NG 2166-302
LP 2166-303
Figure 10.2 Fan Wiring Diagram
38
SWITCHED DC
REGULATOR
2166-305
GAS TUBE
FLAME
SENSE
MODULE (GRAY)
2166-306
WIRE HARNESS
2166-304
FLAME
MODULATION
GROUND*
RED
JUMPER WIRE
GREEN
(MAIN)
* NOTE: GROUND FROM WIRE HARNESS
MUST BE ATTACHED TO UNPAINTED METAL
Heat & Glo • Cosmo-I30AU • 2243-900 Rev. V • 6/14
• An IntelliFire Plus™ Wireless Control or WSK-21 wired
wall switch may be used with the IntelliFire Plus™ Igni-
tion System.
• A standard ON/OFF switch is compatible.
WARNING! Risk of Shock! Label all wires prior to dis-
connection when servicing controls. Wiring errors can
cause improper and dangerous operation. Verify proper
operation after servicing.
WARNING! Risk of Shock! Replace damaged wire with
type 105° C rated wire. Wire must have high temperature
insulation.
POWER CORD ASM
2222-374
PILOT OPTIONS
NG 2090-012
LP 2090-013
IGNITOR
AUX300 MODULE
2166-340
TO VALVE
AUX1 AUX2
BATTERY PACK ASSEMBLY
4067-223
BLACK
OPTIONAL
RED
WALL SWITCH
2187-198
OR
SURROUND
SWITCH
FAN ASSEMBLY
GFK210-240V
Advertisement
Table of Contents
