Table of Contents
Advertisement
MODEL
COSMO-I30AU
TABLE 1
TERMINATION CAP
EXHAUST
COLLAR
WARNING: THE EXHAUST PIPE MUST
ONLY BE CONNECTED TO THE EX-
HAUST STARTING COLLAR OF THE
UNIT AND THE EXHAUST COLLAR OF
THE TERMINATION CAP.
THE INLET AIR PIPE MUST ONLY BE
CONNECTED TO THE INLET AIR COL-
LAR OF THE UNIT AND ATTACHED
TO THE INLET AIR COLLAR OF THE
TERMINATION CAP. THE APPLIANCE
WILL NOT OPERATE PROPERLY IF
INCORRECTLY CONNECTED.
THIS IS A BALANCED FLUE HEATER
AND REQUIRES THE USE OF
BOTH FLUE LINERS AND MUST
TERMINATE TO THE CAP.
Figure 8.8
LINK-DV30B
CHIMNEY PLATE
(MADE TO ORDER)
INLET AIR
COLLAR
Heat & Glo • Cosmo-I30AU • 2243-900 Rev. V • 6/14
FLUE TERMINATION APPROVAL
VERTICAL TERMINATION CAP
SLP-TVHW
FLEXIBLE FLUE
MINIMUM TOTAL FLUE
RUN 10 ft. (3 m)
MAXIMUM 39 ft. (12 m)
MINIMUM 1/4 in. (6 mm )
NON-COMBUSTIBLE BASE (UNDER UNIT)
27
Advertisement
Table of Contents
