Icom IP100H Demonstration Setup Manual page 51

DGX-IP1000C/IP100H -V1.0
When sending a message from a TR 1 (IP100H) to an IP100FS
Sending a message!
TR 1
Access point
(1) Turn ON TR 1's power, and start up the IP100FS.
(2) Push to enter the message select mode, and then select a desired message.
(3) Push to select the IP100FS's ID.
Push TR1's [PTT] to send the selected message to the IP100FS
The IP100FS displays the message, as shown below.
After sending, release TR1's [PTT].
IP1000C
48
IP100FS
The received message is displayed.