Vertex Standard VXA-300 PILOT III Operating Manual page 51

14 TEMP
Function: Correcting the thermometer setting.
Available Values: –127 ~ +127 (x0.1 °C)
Default Setting: 000 (ºC)
This allows you to calibrate the internal thermometer with
a known-to be-accurate source.
15 UNIT
Function: Selects the measurement units for the tempera-
ture sensor.
Available Values: °F/°C
Default Setting: °F
16 TOT
Function: Setting of the Time-Out Timer countdown time.
Available Values: 1/3/5/oFF (minutes)
Default Setting: oFF
The Time-Out Timer shuts off the transceiver after con-
tinuous transmission exceeds the programmed time.
17 DIMM
Function: Setting of the display brightness level.
Available Values: LV1 ~ LV4
Default Setting:LV3
VXA-300 P O
ILOT
M "S
ENU
M
PERATING ANUAL
" M
ET ODE
18 KEY1
Function: Programming the primary (momentary press
mode) [ USER ] key assignment.
Available Values: no/ANL/PA/PIT
Default Setting: ANL (Automatic Noise Limiter)
See page 41 for details.
19 KEY2
Function: Programming the third (press and hold mode)
[ USER ] key assignment.
Available Values: no/ANL/PA/PIT
Default Setting: PA (Public Address)
See page 41 for details.
49